Ofm GT3977 Bedienungsanleitung PDF herunterladen

Table Top

1 Unit

Center Support Beam

1 Unit

Support Braces

2 Units

Legs

2 Units

Long Screws

6 Units

Short Screws

16 Units

Allen Wrench

1 Unit

Model GT3977 Glass Conference Table - 39” x 77”

Parts Listing

919-362-4765 (fax)

www.ofminc.com

161 Tradition Trail, Holly Springs, NC, 27540

800-520-7471 (voice)

919- 303-6389 (voice)

[email protected]

04.02.2012

STOP

Assembly Instructions

Tools Needed: Allen Wrench (Provided)

*You will need two people to assemble this table. DO NOT attempt to

assemble by yourself.

Please read all instructions before assembly.

Step 1: Using two people, very carefully lay the Table Top (A) upside

down on a flat, clean surface. Attach the Center Support Beam (B)

to the mounting plate on the Table Top (A) by inserting Short

Screws (F) through Center Support Beam (B) and into mounting

plate. Only hand tighten the screws. Repeat for opposite side.

Step 2: While one person holds up the Legs (D), attach the Legs (D) to the

mounting plate on the Table Top (A) by inserting Short Screws (F)

through holes in the Legs (D) and into the mounting plate. Only

hand tighten Screws (F). Repeat for opposite side.

Step 3: Secure Legs (D) by lining up Support Braces (C) with holes on

the Legs (D) as shown.

*Please make note of the distinction between the mounting holes

on the Support Braces (C). Two corners have a severe angle,

while one corner is less severe. The two matching corners should

attach to the Legs (D) as shown.

Attach by inserting Long Screws (E) through Support Brace (C) and

into Legs (D). After attaching Support Braces (C) to both Legs (D)

on one side, line up remaing corner on Support Brace (C) with hole

on Center Support Beam (B) and attach by inserting Long Screw (E)

through Support Brace (C) and into Center Support Beam (B).

Repeat for opposite side. Securely tighten all screws in table.

Assembly Notes:

During assembly, hand tighten screws only. When all screws

are in place, you may then tighten all screws completely.

CAUTION:

1. Do not use this table as a step ladder.

2. Check for loose screws and tighten them every 6 months.

ATTENTION: After assembly, two people are

required to turn table right side up.

Assembly Instructions 1

Inhaltsverzeichnis

Seite 1 - Assembly Instructions

ATable Top1 UnitBCenter Support Beam1 UnitCSupport Braces2 UnitsDLegs2 UnitsELong Screws6 UnitsFShort Screws16 UnitsGAllen Wrench1 UnitModel GT3977

Kommentare zu diesen Handbüchern

Keine Kommentare

Ofm GT3977 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Möbel Ofm GT3977 herunter. OFM GT3977 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Möbel Ofm GT3977